Sunday, September 20, 2015

Samsung Compressor and Turbine Piping Design Standard

Samsung Compressor and Turbine Piping Design Standard

Table of Contents

Page
1. General
1.1 Purpose
1.2 Scope
1.3 Reference

2. COMPRESSOR General
2.1 Compressor Types and Characteristics
2.2 Compressor Comparison

3. COMPRESSOR/TURBINE LAYOUT
3.1 Layout General
3.2 Compressor House Layout
3.3 Installation Height
3.4 Operation & Maintenance

4. Piping LAYOUT
4.1 Compressor Connecting Pipe
4.2 Turbine Connecting Pipe
4.3 Oil System Connecting Pipe
4.4 Strainer Installation
4.5 Expansion Joint Installation

5. NOZZLE Load Calculation Procedure & Consideration
5.1 Standard
5.2 Calculation & Review Procedure
5.3 Consideration

6. PIPING SUPPORT
6.1 Compressor/Turbine Support General
6.2 Support Consideration by Compressor
6.3 Consideration by Support Type
6.4 Structure Strength by Support

7. Work Activity by Design Phase

8. Revision History

APPENDIX
Ⅰ. Compressor Pipe Fixed Point Selection Method
Ⅱ. Compressor Pipe Construction Method(SAMPLE)
Ⅲ. Reference Plot Plan (MOP, GSP-5, PEMEX-Tula, IOCL)

Purpose
This Manual aims to reinforce and standardize the Piping Layout (Incl Supports) for Compressor
/Turbine systems for oil refinery and Chemical Plants designed by SECL.






Please note, we do not host any material and these are being shared from links found online. If anyone has objection with this, kindly email at ankit@pipingguide.net. Proper action shall be taken within 48 hours. 

Get Notified for new Tutorials:
*Check your email to confirm your subscription*


0 comments :

Post a Comment

 

© 2011 PIPING GUIDE - Designed by Ankit | ToS | Privacy Policy | Sitemap

About Us | Contact Us | Write For Us